Uninstalling the Symantec Endpoint Protection client for Windows

HOWTO80803
Last Updated April 24, 2019

You can uninstall the Windows client in the following ways:

If the Symantec Endpoint Protection client software uses a policy that blocks hardware devices, the policy blocks the devices after you uninstall the software. If you do not disable the device control by policy before you uninstall, use the Windows Device Manager to unblock the devices.

To uninstall the Symantec Endpoint Protection client for Windows

  1. In the console, on the Admin page, click Install Packages, and then click Client Install Settings.

  2. Under Tasks, click Add Client Install Settings.

    Note:

    If you have previously created a custom client installation settings configuration, you can modify it under Tasks, and then click Edit Client Install Settings. Modifying an existing custom configuration does not modify previously exported install packages.

  3. On the Basic Settings tab, check Remove existing Symantec Endpoint Protection client software that cannot be uninstalled.

  4. Read the message, and then click OK.

  5. Click OK.

See Uninstalling the Symantec Endpoint Protection client for Mac.

See Uninstalling the Symantec Endpoint Protection client for Linux.

Legacy ID: v16703859_v81626096
  • Endpoint Protection

    14.2 RU1, 14.2 MP1, 14.2, 14.0.1 MP2, 14.0.1 MP1, 14.0.1, 14.0.0 MP2, 14 MP1, 14, 12.1 RU6 MP8, 12.1 RU6 MP7, 12.1 RU6 MP6, 12.1 RU6 MP5, 12.1 RU6 MP4, 12.1 RU6 MP3, 12.1 RU6 MP2, 12.1 RU6 MP1, 12.1 RU6, 12.1 RU5, 12.1 RU4, 12.1 RU3, 12.1 RU2

Vielen Dank für Ihr Feedback. Wenn Sie weitere Kommentare haben, können Sie diese unten eingeben. (Einloggen erforderlich)

    © 1995-2019 Symantec Corporation