This topic explains the options that are configured using the Core server with user interface mode. to work with the Core server only mode.
If you select ICAP, you must configure certain ICAP-specific options. You must also configure the ICAP client to work with Symantec Protection Engine. For more information, see the ICAP client documentation.
describes the configuration options for ICAP.
Table: Protocol-specific options for ICAP
To configure ICAP options
In the console on the primary navigation bar, click Configuration.
In the sidebar under Views, click Protocol.
In the content area under Select Communication Protocol, click ICAP.
In the Manual Restart Required dialog box, click OK.
Whenever you switch protocols, you must restart the server. You can continue to make and apply changes in the console. However, the changes do not take effect until you restart the Symantec Protection Engine service.
Under ICAP Configuration, in the Bind address table, select the scanning IP addresses that you want to bind to Symantec Protection Engine. Check Select All to select every IP Address in the Bind address table.
Only four IP addresses appear in the Bind address table. Click the scroll bar to view additional IP addresses.
By default, Symantec Protection Engine binds to all interfaces.
In the Port number box, type the TCP/IP port number that the client application uses to pass files to Symantec Protection Engine for scanning.
The default setting for ICAP is port 1344. If you change the port number, use a number that is equal to or greater than 1024. No other program or service should use this port number. You must use the same port number for every scanning IP addresses that you want to bind to Symantec Protection Engine.
On the toolbar, select one of the following options:
Imported Document Id