During a remote installation, you see the error message "Error: Login to failed. Check the username and password and try again."
The Symantec Endpoint Protection Manager Find Unmanaged Clients wizard requires the ability to authenticate as an administrator. By default, if the password is blank, the wizard cannot authenticate, and the installation fails.
Note: To check if this document describes the computer in question, download and run a pre-install check with SymHelp.
To set the administrator password
Right click My Computer, and then click Manage.
Expand local Users and Groups.
In the right pane, right click Administrator, and then click Set password.
Rate this Article
This is machine translated content
Login to Subscribe
Please login to set up your subscription.
Didn't find the article you were looking for? Try these resources.