After deploying an image of an IBM/Lenovo laptop computer to a new machine the destination machine will not boot to windows. No ghost error will be seen but the client machine may boot to a blinking cursor or a black screen.
Deployment solution, Ghost solution sutie, Ghost standard tools
This behavior usually occurs as a result of problems with the boot sector. Try the following to resolve the issue.
Create the image with the use of the -ib command line switch.
The PreDeskTop prevents the laptop to boot up. The PreDeskTop that must be Disabled in the BIOS under the Security or Advanced tab depending on IBM model. Some models list PreDeskTop under Security, Fingerprint, PreDeskTop Authentication.
The path to the setting for IBM G40 thinkpad:-- BIOS, Security, Predesktop = 'Disabled'
The path to the setting for Lenovo Think Center -- BIOS, Security, FingerPrint setup, Preboot Authentication = 'Disabled'
Both the source and target hard drives should be installed in the IBM computer during the imaging and restore process so that they are embedded in their native IBM BIOS environment. In some cases, cloning the hard drives on a different computer results in the IBM proprietary boot record not being properly defined.
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your
For security reasons, your link to this document has expired. Please click on the attachment link to access this file.
The attachment that you are looking for no longer exists.
There has been an issue retrieving your attachment. Please try again.
Currently server is down.
Didn't find the article you were looking for? Try these resources.