You may get 'signature' errors or failure to boot to Windows after restoring an image.
- Blue screening can occur when using SATA / AHCI hard drives. They are best accomodated by using the latest version of Ghost, 11.5 and Windows PE. Using an older version of Ghost may require changing the setting for SATA in the BIOS to ' Legacy ' or ' Compatibilty '.
- In some cases you must also use the command line switch -FDSP to preserve the disk signature when restoring an image.
- Additional switches may be required: -FNI -FFX -NOIDE -NOUSB
- In some cases you may have to remove a laptop computer from a docking station.
- Other security settings in the BIOS can require user intervention. Disable them in the BIOS to allow for automated Ghosting.
Document: 'IBM Laptop fails to boot after cloning an image'available at http://service1.symantec.com/support/on-technology.nsf/docid/2006111517032525
Document "'Signature Failure' or 'Bad Block' errors when restoring an image to IBM laptops'" available at http://service1.symantec.com/support/on-technology.nsf/docid/2005011108290525
For information about usign Ghost with Lenovo laptops, check the link http://www-307.ibm.com/PC/support/site.wss/document.do?sitestyle=lenovo&lndocid=MIGR-57590.
- IBM laptops that have a fingerprint reader can have other settings under ' Security ' that would require user intervention when using Ghost in a pre-os environment. Alternatively, you could use ' hot imaging ' from the Console which would allow you to take an image while the Windows operating system is running.
Imported Document Id