What can cause the error, "Unable to boot to DOS automation (status code 116)"?
The message "Unable to boot to DOS automation" means that it was unable to boot the client into a state where it could be imaged (that is, PXE is missing, BootWorks is missing, or a BootWorks Boot Disk is missing).
Verify that you have:
PXE setup and functioning correctly, or
BootWorks installed and functioning correctly, or
A functional BootWorks Boot Disk is in the floppy disk drive.
Also make sure RIS (Remote Installation Service) is not on the network. Active Directory users and computers > RIS computer itself > Right Properties. Select Remote install, and uncheck the Respond to client computers requesting service.
Applies To Deployment Solution 6.x
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your
Would you like to be subscribed to future notifications for this article?
For security reasons, your link to this document has expired. Please click on the attachment link to access this file.
The attachment that you are looking for no longer exists.
There has been an issue retrieving your attachment. Please try again.
Currently server is down.
Didn't find the article you were looking for? Try these resources.