Enforcer 6100 Series Appliance will not authenticate clients
From the Enforcer kernel.log: [radsock.c]: Thread<sylane.acc.in:719> Fail to Bind to port <XXXX>, where xxxx is the port that is having the issues
This indicates a port conflict on the port listed in the kernel.log.
Check the RADIUS accounting port and make sure that it is not also set at 1812.
Remove port conflict on Enforcer via the command line. Config > Advanced > Radius > Show will tell you what the RADIUS accounting port is set to. You can change it by Entering in Config > Advanced > Radius > Acc_Port
Enforcer 6100 Series Appliance in LAN mode.
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your
For security reasons, your link to this document has expired. Please click on the attachment link to access this file.
The attachment that you are looking for no longer exists.
There has been an issue retrieving your attachment. Please try again.
Didn't find the article you were looking for? Try these resources.