During compilation, table merge errors occur when adding more than one of Wise merge modules.
Steps to reproduce:
Create a new empty project.
Under Tool Options, mark the checkbox option for " Display error if merge modules conflict with main installation rows" under the General tab.
Add WiseMDAC28.msm and Wise_CR85_ActiveXDesignerRuntime.msm (or any two Wise created merge modules).
The WisePathVariable table is conflicting between two or more merge modules.
Several of the merge modules Wise created contain the WisePathVariable table. This causes errors when the 'Display error if merge modules conflict with main installation rows' option is enabled since the table always has the same default values, and an error will occur if two rows being merged have the same key value.
There are a few workarounds for this issue:
Disable the 'Display error if merge modules conflict with main installation rows' option
Modify the .MSMs in Orca and remove the WisePathVariable table
Ignore the merge errors for these merge modules. It appears that the .MSI is successfully compiled and contains everything from the merge module
Applies To Wise Package Studio 6.1 Wise For Windows Installer 6.2
Rate this Article
This is machine translated content
Login to Subscribe
Please login to set up your subscription.
Didn't find the article you were looking for? Try these resources.