More detail is needed on what caused the NetApp syslog error, "The filer received status message Internal server error and error code [0x5] from vscan".
The filer received status message Internal server error and error code [0x5] from vscan
Due to the return code, Data ONTAP is only aware of return code as "ok" for clean verdict or "not ok" for something other than clean. If the result differ from a clean verdict the mentioned error [0x5] is the default message that gets logged in the NetApp syslog (messages log file).
To get more information on what specific error was thrown by Symantec AntiVirus for Network Attached Storage 5.x (Symantec Scan Engine) or Protection Engine 7.x, the Scan Engine log file will need to be reviewed.
Using the Scan Engine GUI, choose the Reports option, then Detailed. You can choose a time and date to filter the logs by as well as the error type. To choose all log entries, press Ctrl-A to check all of the boxes. When you run the report, you can use a Find function to locate the entry for the specific file name referenced in the NetApp error.
This should allow the admin to determine what specific error caused the NetApp syslog error, "The filer received status message Internal server error and error code [0x5] from vscan". Further troubleshooting can continue once the specific error has been identified.
Symantec AntiVirus for Network Attached Storage 5.x (Symantec Scan Engine)
Symantec Protection Engine for Network Attached Storage 7.x
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your
For security reasons, your link to this document has expired. Please click on the attachment link to access this file.
The attachment that you are looking for no longer exists.
There has been an issue retrieving your attachment. Please try again.
Currently server is down.
Didn't find the article you were looking for? Try these resources.