After authenticating successfully at the PGP BootGuard, the screen remains with a blinking cursor or the system simply reboots and the operating system fails to load.
The following issues have been reported with certain models after encrypting with Symantec Drive Encryption:
System stuck with a blinking cursor after authentication at PGP BootGuard
System reboots after authentication at PGP BootGuard
This issue can occur on systems with Opal compliant disks which are currently not supported with Symantec Drive Encryption
Symantec Corporation is committed to product quality and satisfied customers. This issue is currently being considered by Symantec Corporation to be addressed in a forthcoming version or Maintenance Pack of the product. Please be sure to refer back to this document periodically as any changes to the status of the issue will be reflected here.
A list of Opal-drives and models that could contain such drives can be found here:
Possible workarounds in some cases are to disable the AHCI-Communication with the drive in the BIOS. Be sure to prepare your Windows Installation prior changing this BIOS-Setting, otherwise you may experience a Bluescreen on Startup. After changing the Drive Communication and a successful boot, encrypt the drive with PGP WDE.
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your subscription.
Didn't find the article you were looking for? Try these resources.