An update needs to be applied to Nukona App Center and the commands to Stop/Start/Restart the daemons need to be run.
No errors are displayed when running these commands.
When installing an update to a Private Cloud tenant of Nukona App Center the services need to be in specific states during portions of the upgrade.
The following commands need to be run with either root or sudo permissions using the terminal:
In order to see if the daemons for the App Center are running the following commands can be run using the terminal.
ps -ef | grep monit
ps -ef | grep push
ps -ef | grep mdm
ps -ef | grep batch
ps -ef | grep wrap
Nukona App Center starts the daemons upon reboot of the server.
*Note* If the environment being worked on has been upgraded several times it is recommended that a check is performed to ensure the daemons are still set to initiate on boot. The following command can be executed in the terminal to confirm this configuration.
There will be many entries in this list. The pertinent ones to spot will be "monit" and "httpd." You will need to verify that 3, 4, and 5 are set to "on."
The output of the previous command should display the following if set correctly:
monit 0:off 1:off 2:on 3:on 4:on 5:on 6:off
httpd 0:off 1:off 2:on 3:on 4:off 5:on 6:off
If either 3, 4, or 5 are set to "off," then the following commands can be issued to enable them.
chkconfig --levels 345 monit on
chkconfig --levels 345 httpd on
The following command can then be re-run to verify the proper configuration.
Nukona App Center 3.0 through 4.1.18 are affected by these commands.
RHEL/CentOS 5.5-5.8 64-bit.
Imported Document Id