DeployAnywhere is properly detecting critical and non-critical drivers but the drivers are not being installed to the destination OS. (%systemdrive%)
When this occurs with critical drivers the system will not boot into production.
The %systemdrive% variable that is being used in the unattend.xml file is not being properly resolved by Microsoft's Minisetup utility
Before implementing this solution consult with Symantec Technical support to ensure that the DeployAnywhere (DA) being used is the latest version and that DA is properly finding the drivers. If the above has been checked and the drivers are still not being installed please do the following:
- Create a Deploy Image Job with two tasks:
- Deploy Image - with 'Include DeployAnywhere for hardware independent imaging' checked
- Run Script- Set the 'Script type' to 'vbscript' and paste the following into the task:
' Modify varSysDrive to be the actual Windows "drive" letter as seen in
' production after rebooting. c:\ will generally suffice
varSysDrive = "c:"
' Modify varAutoProdDrive to be the production drive as "seen" in automation.
' Automation uses X and production is usually c, but you may need to verify.
' If the OS is Windows 7 and a System Recovery partition is on the hard drive the drive will be 'd:\'
varAutoProdDrive = "d:"
Set objFSO = CreateObject("Scripting.FileSystemObject")
Set objFile = objFSO.OpenTextFile(varUnattend, 1)
strText = objFile.ReadAll
strNewText = Replace(strText, "%SystemDrive%", varSysDrive)
c. Modify the script as noted in the script to match your environment
Note: As this is a Microsoft issue Symantec is working with them to address this issue in a more permanent way.
All DS 7.x versions
Imported Document Id