If you use Postfix, configure the Milter API so that MTA can request scan to SMG-SP.
SMG-SP supports Postfix 2.6 or later. To integrate SMG-SP to a Postfix installation, modify the Postfix configuration file. The Postfix configuration file should specify the following information about the Milter protocol:
For more information about the Milter protocol, on the Internet, go to the following article:
SMTP-Only Milter applications
To configure the Milter protocol for Postfix
1. Open the following file in a text editor application:
/etc/postfix/main.cf file
2. Add the following lines:
smtpd_milters = inet:<ip address>:<port>
milter_protocol = 2
<where ip address> is the IP address is the host where the Scanner is installed and <port> is the valid port. The default port is 41001.
3. Save and close the file.