Documentation: Is there a way to throttle or limit VERITAS NetBackup (tm) so it will not use all available bandwidth on the network?
There are situations where a customer may need to limit the available bandwidth to NetBackup to ensure all data gets a chance to traverse the network. This can be useful in networks with firewalls that can be overrun by the amount of NetBackup data traffic.
If the customer needs to limit the amount of bandwidth used by NetBackup, so backups do not use all the available bandwidth, set the limits for both IP subnets and individual clients using the GUI in
Master server | Host Properties | Bandwidth. (see page 216 for details in the 7.0 UNIX System Administrator's guide).
Or use the following entry in the master server's
bp.conf file to reduce or limit the available bandwidth.
LIMIT_BANDWIDTH = 10.222.333.1 10.222.333.255 500 This would limit the entire IP subnet 10.222.333.x to only 500 KB of bandwidth.
LIMIT_BANDWIDTH = 10.222.333.111 10.222.333.111 500 This would limit just the one client with the IP address 10.222.333.111 to only 500 KB of bandwidth.
LIMIT_BANDWIDTH = 10.222.333.111 10.222.333.111 0 This would disable bandwidth limiting for just this one client with IP address 10.222.333.111
Note: Setting the bandwidth higher for an individual client then it is for the range, NetBackup ignores that setting and uses the value for the range.
If the bandwidth limit for an individual client is equal to or lower than the value for the range, the client uses whichever value is the lowest.
LIMIT_BANDWIDTH = 10.222.333.1 10.222.333.255 500 LIMIT_BANDWIDTH = 10.222.333.111 10.222.333.111 300 In the above example, the client would use the lower value of 300 KB.
Note: This does not work with some types of backups (DB2, DataStore, Informix, Oracle, SQL-Backtrack, SQL-Server, Teradata etc.).
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your subscription.
Didn't find the article you were looking for? Try these resources.