When trying to audit a computer using any Policy File, I receive the following error:
ERROR Cannot connect to remote computer: [host name]: 11004: The requested name is valid, but no data of the requested type was found.
When you receive a connection error when trying to audit a host, the error code is produced by Windows, not SecurityExpressions. This error code in particular is in relation to the computer running SecurityExpressions being unable to contact the target host. This error can be reproduced by trying to audit a computer which does not exist on the network.
Run the following troubleshooting steps to help diagnose the cause of the host being unreachable:
Open a command prompt and try to ping the computer name.
Open a command prompt and run an nslookup on the computer name. Also try an nslookup on the computer's IP address and ensure the information matches.
Ensure that the DNS and/or WINS Servers are running and are configured properly. Also ensure they are accessible.
Physically access the target host and test that it has network connectivity. Run ipconfig and ensure that the IP address matches the result of the ping and nslookup tests.
In SecurityExpressions, try auditing the target host by its IP address.
This error is typically caused by network communication failure or name resolution failure.
Applies To SecurityExpressions Console(any version) SecurityExpressions Audit & Compliance Server (any version)
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your
For security reasons, your link to this document has expired. Please click on the attachment link to access this file.
The attachment that you are looking for no longer exists.
There has been an issue retrieving your attachment. Please try again.
Currently server is down.
Didn't find the article you were looking for? Try these resources.