Why do we get "Unknown Transfer ID" when PXE booting?
search cancel

Why do we get "Unknown Transfer ID" when PXE booting?

book

Article ID: 176926

calendar_today

Updated On:

Products

Deployment Solution

Issue/Introduction

When attempting to boot our computers to PXE for imaging, we get a DHCP request prompt, and then quickly receive an error "Unknown Transfer ID." and "PXE-E05" error.  What does this mean?

Cause

This is part of the MTFTP protocol, and is a standard error as found in the RFC per the following table:

 Error Codes

   0         Not defined, see error message (if any).
   1         File not found.
   2         Access violation.
   3         Disk full or allocation exceeded.
   4         Illegal TFTP operation.
   5         Unknown transfer ID.
   6         File already exists.
   7         No such user.

There is supposed to be an "appendix" somewhere that discusses this error, but we were not able to find it.

What we did find, however, from our own MTFTP logging was an error finding the BSTRAP.0 file.  Looking at the images folder, we discovered that folder missing, though it was in the master images folder, which would explain the error in the MTFTP logs.

Resolution

As a temporary workaround, we manually copied the bstrap folder from master images to the images folder, and imaging worked fine.  For a "fix" though, we need to find out why those folders are not kept up-to-date automatically.

Applies To
DS 6.x all versions.