You need instruction to pass connections from Cisco VPN client through your security gateway.
Cisco uses port 10000/TCP for their VPN client to pass encrypted TCP traffic. To use this port on your Symantec security gateway, you must create a rule to allow the TCP traffic to pass through the firewall.
Note: Cisco VPN client software version 4.05 and later may use port 4500.
To create a rule for the firewall to pass Cisco VPN client traffic on port 10000/TCP
Connect to your firewall with the Symantec Raptor Management Console.
In the left pane, expand Base Components and right-click Protocols.
Choose New > Protocol to create a new protocol.
On the General tab, type the following: Name: Encrypted_TCP Description: Encrypted TCP for Cisco VPN Client Base Protocol: TCP
Check the "Display in Rule Window" box.
On the TCP/UDP Port Ranges tab, type the following: Destination Port Range: 10000-10000 Source Port Range: 1024-65535
Create a new rule with the appropriate source, destination, and interfaces. In the Services tab, add Encrypted_TCP to Included Services.
Click Save and Reconfigure.
Cisco VPN client traffic now passes through your gateway.
Imported Document Id
This is machine translated content
Login to Subscribe
Please login to set up your
For security reasons, your link to this document has expired. Please click on the attachment link to access this file.
The attachment that you are looking for no longer exists.
There has been an issue retrieving your attachment. Please try again.
Currently server is down.
Didn't find the article you were looking for? Try these resources.