Important: Part of a series outlining the deployment of a production on premise Symantec Mobility: Suite solution. This is meant to be used supplementary to the published Mobility: Suite Administration and On-premise Installation guides. If there are any recommendations made in this walkthrough which contradict the above mentioned guides, use the recommendations in the guides
1.Begin the Mobility: Suite installation by entering the following, as root, from the mounted ISO’s location: sudo ./setup.sh
2.Ensure that Install Mobility Manager is selected and OK to continue.
Tip: Use the Tab and arrow keys to toggle the selection.
3.Agreeing to the Symantec Corporation terms will allow the installation to proceed:
4.Same for Java, as above:
5.Take note of the default directories and OK to continue:
6.Set the HTTP Configuration wizard port as 8000 (default) and Tab to OK to continue:
7.Select: I want to use my own production database option and OK:
Note: The local-trial-database is not recommended for a production environment.For a Proof of Concept (POC) managing less than 250 devices, the trial database will be sufficient.
8.For deployments managing less than 15,000 devices select Local trail server, otherwise an off-box RabbitMQ server and fall-over server must be created see HOWTO107258
Note: The local trial RabbitMQ instance may only be accessed from the local host, a future off-box RabbitMQ server may be added at a later time.
9.After reviewing the configuration, arrow-down to select Start Installation and OK to continue.
10.The primary installation will take about 10-30 minutes to complete.
11.Do not cancel this process. When the script completes the following line will appear: Please configure your Mobility Manager by navigating your internet browser to http://<FullyQualifiedDomainName>:8000 Installation cannot finalize until configuration is complete:
Note: If any errors in this process will be logged to /var/log/nukona/appcenter-install.log. If the above is not shown, reboot the server and repeat parts IV & V. To troubleshoot the Installation Part II section see