Configuring a computer to access Symantec Web Gateway for installation
You must connect a computer to the management port to initially set up Symantec Web Gateway. You must also configure the IP address and netmask of that computer.
After you install Symantec Web Gateway, you can access it from a browser on any computer in your network. You can also disconnect the computer from the management port and reconfigure the network settings as desired.
The exact method to use to configure the computer network settings depends on the operating system. For example, on Windows XP, access Network Connections on the Control Panel. Access the properties of the Local Area Connection and then access the properties of Internet Protocol (TCP/IP).
For more information about how to configure your computer network settings, see your operating system documentation.
After you configure a computer to access Symantec Web Gateway for installation, run the setup wizard.