To configure Ethernet settings in SMG 1 In the Control Center, click Administration > Hosts > Configuration. 2 Under Hostname, check the Scanner whose Ethernet settings you want to modify and click Edit. 3 On the Edit Host Configuration page, click the Ethernet tab. 4 Edit the Ethernet interfaces as needed by entering an IP, netmask, broadcast, and network address for each Ethernet interface. Change the Scanner or Control Center IP address if needed. 5 For each Ethernet NIC, check Auto Negotiation. Otherwise, select a speed for the connection, and specify half or full duplex operation of the connection. 6 Check Segmentation to offload TCP segmentation from the gateway CPU to the Ethernet card. 7 Check Enable this interface to activate a second Ethernet interface. You can dedicate a second Ethernet interface to handling inbound or outbound traffic only .
Imported Document ID: HOWTO59220
Subscribing will provide email updates when this Article is updated. Login is required to Subscribe