Configuring Symantec Protection Engine to use the RPC protocol
This topic explains the options that are configured using the Core server with user interface mode. to work with the Core server only mode.
Before you can configure any of the RPC protocol options, configure Symantec Protection Engine to use the RPC protocol.
To configure Symantec Protection Engine to use the RPC protocol
In the console on the primary navigation bar, click Configuration.
In the sidebar under Views, click Protocol.
In the content area under Select Communication Protocol, click RPC.
In the Manual Restart Required dialog box, click OK.
Whenever you switch protocols, you must restart the server. You can continue to make and apply changes in the console. However, the changes do not take effect until you restart the Symantec Protection Engine service.
On the toolbar, select one of the following options:
Saves your changes.
Use this option to continue making changes in the console until you are ready to apply them.
Applies your changes.
Your changes are not implemented until you apply them.