You can make necessary changes in the OCIL v2.0 XML file on your local computer and then import the file into CCS Assessment Manager.
Apart from the OCIL questionnaires, you can also import the XMLQ questionnaires that belong to CCS Assessment Manager 10.5 or earlier. When you import an XMLQ file, the questionnaire is converted from the XMLQ format to the OCIL format.
Questionnaire import is not supported in case of the following:
The OCIL files that contain cyclic references from one questionnaire to another questionnaire within the same document.
The OCIL and XMLQ files that contain hopping options.
The questionnaire that you import must have the document tag. An OCIL document without the document tag is not valid.
The version of an imported XMLQ file is reset to 1 if the existing questionnaire version is greater than 32000.
When you import an OCIL questionnaire, the severity value for a 'Fail' result is set to 3 and the severity value for a 'Pass' result is set to 1 by default. For the other results such as Error, Unknown, Not Tested, and Not Applicable, the severity value is 0 by default.
At the time of import, variables, artifacts, and the test action of numeric and string questions are imported successfully, but they are not used in the assessment process.
After evaluation of a questionnaire as per OCIL specifications, the assessment report displays the result states as mentioned below:
OCIL result after evaluation
Result state in the assessment report
To import a questionnaire
In the CCS Assessment Manager console toolbar, go to File > Import.
In the Import dialog box, navigate to the location where you have saved the questionnaire and then click Open.
Click OK on the message prompt that confirms the successful import of the questionnaire.
An error message displays if you have selected an invalid file. Click OK on the error message and then repeat 2.