After you perform the initial steps of starting the appliance setup, the next step is to configure the Ethernet interfaces.
See Starting the appliance software set up.
To specify Ethernet interfaces
When you are prompted, type the IP address for the Ethernet interface that is labeled 1 on the back of the appliance.
When you are prompted, type the subnet mask for Ethernet interface 1.
When you are prompted if you want to use the second Ethernet interface, interface 2, type one of the following responses:
You want to use interface 2.
You do not want to use interface 2.
Skip to the next procedure.
See Specifying a static IP address for routing.
When you are prompted, type the IP address for Ethernet interface 2.
When you are prompted, type the subnet mask for Ethernet interface 2.
To continue installation, next you specify a static IP address for routing.
See Installing the Symantec Messaging Gateway product.
Subscribing will provide email updates when this Article is updated. Login is required to Subscribe
Thanks for your feedback. Let us know if you have additional comments below. (requires login)
This will clear the history and restart the chat.