Scanner services are not started by default after a restore operation. If you bypass the site setup wizard and execute the db-restore command from the command line interface, Scanner services must be started manually after the restore operation.
To restore an appliance from a different network configuration
Install and configure the new host.
The host role that you chose during configuration must be identical to the role of the backup. For example, if the backup is taken from an all-in-one deployment, the new host role must be Control Center and Scanner.
Register the new host by importing the license file from the site setup wizard.
Optionally, complete the site setup wizard.
If you complete the site setup wizard, the setup information is overwritten by the restore operation. However, completing the site setup wizard enables you to perform a software update and restore through the Control Center instead of the command line interface. The site setup wizard also lets you create virtual IPs before the restore operation.