Configuring multicast options to deploy image

You can configure the image multicasting settings through the following options:

  • Settings > Deployment > Image Multicasting menu

  • Settings > All Settings > Deployment and Migration > Image Multicasting option

To configure multicast options

  1. In the Symantec Management Console, on the Settings menu, click Deployment > Image Multicasting.

  2. Specify values for the following fields:

    IP range

    The range of IP addresses to use for image deployment.

    Port range

    The range of port numbers to use for image deployment.

    Threshold

    The minimum number of clients that need to be part of the group before multicasting is used.

    Speed

    The maximum speed to use when multicasting to avoid flooding the network with too much traffic. As this number increases, there is a greater chance for dropped packets and slower speeds to occur.

    Timeout

    The maximum number of minutes to wait for the specified number of clients to join the group. If this number is reached, your images are deployed separately.

  3. Click Restore defaults to use the default configuration settings.

  4. Click Save changes.

See About Imaging client computers

Imported Document ID: HOWTO99980
Legacy ID: v51016335_v99830789

Thanks for your feedback. Let us know if you have additional comments below. (requires login)

    © 1995-2019 Broadcom. All Rights Reserved. The term “Broadcom” refers to Broadcom Inc. and/or its subsidiaries.