Command line interface changes in Symantec Brightmail gateway Version 9.0
Last Updated January 26, 2010
In Symantec Brightmail Gateway version 9.0, some commands that existed in version 8.0 and previous versions were renamed, incorporated into other commands, or removed. The functionality of some commands was changed in Symantec Brightmail Gateway version 9.0.
Symptoms You are trying to use
some old commands via SSH as admin user and no longer able to run old commands.
The Removed commands table describes the commands that were removed in Symantec Brightmail Gateway version 9.0. In most cases, new commands replace the functionality of the removed commands.
Table 1-2 Removed commands
New command for version 9.0
Replaced with agent-config.
Replaced with delete. In version 9.0, the clear command clears the screen.
The delete all command returns your appliance to the original factory configuration. Unlike the old clear all command, the delete all command deletes backup files. The Control Center Factory Reset option now also deletes backup files.
Part of diagnostics.
Replaced with show --date.
Replaced with delete cores.
The functionality of the dn-normalize command is not available in version 9.0.
Replaced with show --eula.
Replaced with cc-config http.
Replaced with update install.
Replaced with list.
Replaced with monitor mta.
Replaced with password.
Replaced with mta-control pause-mode.
Replaced with rpmdb --repair.
Replaced with delete files.
Replaced with cc-config port-443.
Replaced with sshd-config.
Replaced with sshd-config --version.
Replaced with show --info.
Replaced with monitor system.
The functionality of the tls-ca-cert-control command is not available in version 9.0.
References Release notes for Symantec Brightmail Gateway 9.0.