After upgrading using the command line interface (CLI) Control Center shows Unknown version
Last Updated December 21, 2011
You upgrade SMG to version 9.5.3 using the CLI and you notice that in the Control Center you see Unknown version displayed under: Administration -> Hosts -> Version -> Updates in addition you may also see the previous version (prior to upgrade) listed on the Login page for the User Interface.
This is only a minor, cosmetic issue and it should be automatically corrected once the Control Center runs an update check; however, if you want to manually correct the issue you can use the steps under the Solution part of this article.
To manually correct the issue:
On each scanner: 1) Login to the scanner as admin 2) type rpmdb -r 3) Logoff from SSH
On the Control Center: 1) Login to the control center using SSH as admin 2) type service controlcenter stop 3) type rpmdb -r 4) type service controlcenter start 5) Logoff from SSH
- Upgrade done through CLI to version 9.5.3
Imported Document ID: TECH176739
Subscribing will provide email updates when this Article is updated. Login is required to Subscribe