SEP clients did not run the command sent from SEPM and SEPM monitor showed 0% command finished
Last Updated October 11, 2012
Ran the command, "Update content" from the Symantec Endpoint Protection Manager (SEPM). However, none of Symantec Endpoint Protection (SEP) clients appear to have accomplished the command. In the SEPM Monitors tab, the command status showed 0% command finished. The SEP clients display a green dot in the tray, and from the SEPM, the clients listed in the Clients tab are also displaying a green dot. All SEP clients are also up to date with the correct virus definitions.
Restart the SEPM system, then it runs normally.
Win Server 2008 standard X86,32 bit
Symantec Endpoint Protection 12.1
Imported Document ID: TECH184732
Subscribing will provide email updates when this Article is updated. Login is required to Subscribe