Error: "No default or UI configuration directive found!" when installing linux based product from an .ISO on a bootable disc

TECH213826

Last Updated September 02, 2015

Installing SSIM, SWG or SMG from an .iso file on a bootable disc or in a virtual environment

The disc boots, but displays the following error before ISO Linux loads:

Error: "No default or UI configuration directive found!" when installing SSIM from an .ISO on a bootable disc

The .iso file is likely corrupt.

Use the provided md5 file to check consistency of the .iso file. It may need to be redownloaded, or recopied to the location it is actually being installed from. Make sure to verify the actual file that is being installed.

Imported Document ID: TECH213826

Thanks for your feedback. Let us know if you have additional comments below. (requires login)

Error: "No default or UI configuration directive found!" when installing linux based product from an .ISO on a bootable disc

Situation

Solution

Was this Article Helpful?

Error: "No default or UI configuration directive found!" when installing linux based product from an .ISO on a bootable disc

Situation

Solution

Subscribe To This Article

Related Products

Was this Article Helpful?