Endpoint Agent is blocked by Network Access Control System, like NetMirror
Article ID: 159898
Updated On:
Products
Data Loss Prevention Endpoint Prevent
Data Loss Prevention Endpoint Discover
Issue/Introduction
Endpoint Agents cannot connect to the Endpoint Server.
Error in agent's log indicates "Authentication failure; agent cannot authenticate endpoint server"
Resolution
One possible cause for the problem is a network access control system, like NetMirror for example. NetMirror sends TCP reset packets to terminate any unauthenticated traffic.
Set the traffic between Endpoint Agent and Endpoint Server into a trusted list in the network access control system (NetMirror in this example). Otherwise, the network component of the network access control system will terminate the communication between them by sending TCP reset packets.
Note: Please contact Symantec Technical Support for further assistance if this is not the cause of your issue.
Feedback
Yes
No
Powered by
