Power Supply column shows "Failure" in the GUI for Symantec Web Gateway (SMG).
Issue might occur on following appliance models: SWG8490 (Dell PowerEdge R720)
Power Supply redundancy disabled in the BIOS of the appliance.
Enable power supply redundancy in the BIOS or iDRAC.
Steps to enable via BIOS: 1. Boot the system, and press F2 for setup 2. Select "iDRAC Settings" 3. Select "Power Configuration" 4. Under "Power Supply Options", check the setting "Redundancy Policy", if it says <not Redundant>, it should be changed to <Input Power Redundant> 5. Reboot the system to fully apply the change.
Steps to enable via iDRAC: 1. Go to Overview -> Server -> Power/Thermal 2. Select "Power Configuration" tab 3. Select "Power Configuration" sub-tab 4. Select "Power Supply Options" section 5. Under "Redundancy Policy" if you see "Not Redundant", switch to "Input Power Redundant" 6. Reboot the system to fully apply the change
Subscribing will provide email updates when this Article is updated. Login is required.