When configuring ProxySGs in a fail-over pair, it is important to configure the same multicast address on both proxies. It is also important for the device that sits between the appliances to forward the multicast packets.
If you want to use 22.214.171.124 as the multicast address for example, both proxies have to have 126.96.36.199 configured as the multicast address to use.
If both units act as master even after configuring the same multicast address, the likely cause of the issue is that the switch connecting the proxies isn't forwarding the packets.
To troubleshoot this type of issue, a packet capture should be taken and examined.
If no multicast packets are seen, the HA configuration is either incomplete or disabled
If multicast packets are sent but not received, the switch isn't forwarding multicast packets
If multicast packets are sent and received but HA still doesn't work, a password mismatch could be causing this
Imported Document ID: 000015608
Subscribing will provide email updates when this Article is updated. Login is required.
Thanks for your feedback. Let us know if you have additional comments below. (requires login)
Subscribed to the Article.
Unable to subscribe
Thanks for your additional feedback !!!
Enterprise Support Virtual Agent
Rate Me :
Tell us more:
Welcome! My name is Sami, the Enterprise Support Virtual Agent answering technical support questions.