This article describes possible ways to determine the Service Patch (SP) installed on a chassis.This article describes possible ways to determine the Service Patch (SP) installed on a chassis.
To determine the SP installed on the X-Series chassis.
Use any of the following methods to determine which SP is installed on a chassis:
Run the CLI command
show current-release verify-rpm
CBS# show current-release verify-rpm Copyright (c) 2000-2012 by Crossbeam Systems, Inc. All rights reserved. Version: XOS 8.5.4 [May 25 2010 12:16:42] (bldmgr) gcc: gcc version 2.96 20000731 (Linux 7.3 2.96-112) CVS_Label: XOS-8_5_4_0-20100525_1 Kit_Number: 24
Upgraded rpm:crossbeam-xos-ap-kernel-EL-VsxE_smpxos-8.5.4-43 from: crossbeam-xos-ap-kernel-EL-VsxE_smpxos-8.5.4-24 on vsx_common
Result:The XOS kernel for VSX was patched with an SP. The installed kit level is 43. It replaces the original version "24" of the RPM, shown in the second line of the output.
Note: The output of the command
show current-release verify-rpm is also included in the output of the
show tech-support command.
Open a a UNIX prompt on the CPM and run the command
[root@CBS rpm]# /crossbeam/bin/cbs_verify_rpm Upgraded rpm:crossbeam-xos-cp-daemons-9.5.4-37 from:crossbeam-xos-cp-daemons-9.5.4-30 on CPM
Upgraded rpm:crossbeam-xos-ap-kernel-EL5-ElSalvador_smpxos-9.5.4-36 from:crossbeam-xos-ap-kernel-EL5-ElSalvador_smpxos-9.5.4-30 on vsx_common
Result: Two SPs were installed in this example. CPM daemons were patched using SP kit level 37 and the APM v5 Linux kernel was patched using the SP kit level 36.
From the UNIX prompt, manually check the RPM versions on either the CPM or on the VAP member (depending on the nature of the SP) for a specific SP kit level. Use the following syntax: