Presents example output of the show interface detail command
show interface detail command displays the current state for a physical interface. If no interface is specified, status is displayed for all physical interfaces. The
detail parameter displays verbose information, and allows you to specify additional parameters to filter the verbose output to display only data for the physical line, IPv4, IPv6, or non-IPv4 frame types, interface type, or to display data for a specific interface. The IP frame type parameters apply only to NPM interfaces.
With the exception of management interfaces, the MTU setting is defined at the circuit level. Use
show circuit to display the MTU.
Besides many other details, it shows rates per minute for displayed counters allowing you to better understand traffic being processed at the time of command execution.
Below is presented example output for one of interfaces:
# show interface detail Gigabitethernet 1/1 is up Interface is not in use Hardware address is N/A SFP info: phy_present|phy_good Media Type: Copper, Vendor Name: Molex Inc. MTU N/A, BW 1 Gigabit, full-duplex, auto-negotiation is enabled Last clearing of "show interface" counters Tue May 22 10:37:52 2012 PHY stats: Statistics on physical line Received: Total frames 65145 (bytes 6336192) Broadcast frames 0 Undersized frames 0 Oversized frames 0 Throttles 0 Total errors 0 Frame check sequence (FCS) errors 0 Frame errors 0 Overrun errors 0 Ignored errors 0 Transmitted: Total frames 0 (bytes 0) Underrun errors 0 Total errors 0 Collisions 0