There is an erroneous Link Down alarm generated for the primary interface of redundancy-interface config when a faiilover occurs from primary to backup interface. Workarounds are available and the fix is implemented in future XOS versions.There is an active 'Link Down' alarm for an interface, which is the primary interface of the redundancy interface configuration, but the interface seems to be up as per the show interface status and the alarm doesn't clear.
ID Date Source Description -- ---- ------ ----------- 1382 Feb 21 10:35:34 ap10 Routing protocol NSM failed 1380 Feb 21 10:35:32 ap5 Routing protocol NSM failed 1377 Feb 21 10:35:12 np3 Link down 3/1 1322 Feb 21 10:29:54 np3 Link down 3/7 <- FALSE
x80_245# sho interface ethernet 3/7 Ethernet 3/7 is up <--------------------UP Interface is in use Hardware is 10Gigabitethernet, hardware address is N/A SNMP Interface Index 17 SFP info: present
In a redundancy-interface configuration setup, when the traffic is failed over from the primary interface to the backup interface, the primary interface is erroneously generating a Link Down alarm.
The fix for this issue has been implemented in XOS version 9.6.3 and above, and it is also targeted for XOS 9.5.7 (at the time of this writing a release date is not available for 9.5.7 - it is recommended to stay updated with the latest maintenance releases).
There are 2 workarounds:
1. Bounce the interface
i.e. Disable/enable the primary interface that has the Link Down active alarm.
2. Re-configure the redundant interface
i.e. Remove the redundancy-interface configuration for the interface that has the alarm, save configuration, and then re-enter the redundancy-interface configuration that was removed.
Imported Document ID: 000019397
Subscribing will provide email updates when this Article is updated. Login is required.