How to display the maximum concurrent connections setting via the Check Point command lineN/A
This article explains how to verify Check Point Maximum Concurrent Connections configuration using the command line instead of the GUI.
Check Point has a GUI parameter to set the maximum concurrent connections allowed in a cluster. This parameter can be found under Gateway Cluster Properties -> Capacity Optimization -> Maximum concurrent connections in the Check Point GUI.
By default, VSX uses 15000 and FW1/SG 25000. If you cannot access the GUI to see current setting , the parameter can be displayed using the following commands:
vsx_1 (X80): [vs0] root$ vsx stat -v -l
Connections number: 0
Connections peak: 0
Connections limit: 15000 (this is the value configured in the GUI)
FW1 or CPSG:
fw_1 (x80): root$ fw ctl pstat
Machine Capacity Summary:
Memory used: 1% (10MB out of 800MB) - below low watermark
Concurrent Connections: 0% (1 out of 24900) - below low watermark (25000 is the value configured in the GUI)
Imported Document ID: 000019639
Subscribing will provide email updates when this Article is updated. Login is required.
Thanks for your feedback. Let us know if you have additional comments below. (requires login)
Subscribed to the Article.
Unable to subscribe
Thanks for your additional feedback !!!
Enterprise Support Virtual Agent
Rate Me :
Tell us more:
Welcome! My name is Sami, the Enterprise Support Virtual Agent answering technical support questions.