Describes steps needed to connect NPM-8600 console port
In order to connect to the serial port located on an NPM-8600, the same type of cable should be used as when connecting to CPM console port. Depending on the dongle (DB9/IDC10 connector cable) type, an adapter may be necessary.
1). Connect the host to port A on the NPM-8600.
The dongle should be connected to "PORT A" on the NPM-8600. Port A is located on the top left corner of the board when it is pulled out from X40/X80 chassis.
Once the dongle is connected to the NPM-8600, the host system with the VT100 terminal should be connected to it via DB9/DB9 cable.
2). Launch the VT100 compatible terminal application and enable output logging to the file.
Launch VT100 compatible terminal application (ie. minicom under Linux/Unix, PuTTY under Windows). The default settings are: 9600 8N1, no flow control. Enable logging output from the terminal to the file.
3). Boot the NPM.
Re-insert the NPM-8600 into it's slot or restart NPM if the dongle was attached earlier.
The NPM starts booting and displays information as below:
### Crossbeam Systems, Inc. Bootstrap Complete. Rev 126.96.36.199 INFO - Executing cold self-test. .... ###
A successful NPM-8600 boot should finish with the following messages:
### init: rc: [I] : Waiting for cbsnpmcfgd to finish initial configuration... cbsif: Port 25, Up 10000Mbs Full duplex.
BusyBox v1.2.1 (2009.11.02-23:12+0000) Built-ion shell (ash) Enter 'help' for a list of built-in commands.
/ # ####
Imported Document ID: 000019939
Subscribing will provide email updates when this Article is updated. Login is required.