How to fix an APM in DOWN stateAfter running "
show chassis" you see that there is an APM that is in Down state.
If you try to do a
/crossbeam/bin/cbs_reset_slot <slot number>
And doing a "
tail -f /var/log/messages" you see a message saying "
no applicable record for slot" after the BOOT REQUEST message.
One possible recovery procedure is the following:
To clear that condition you need to do the following:
1) On xos CLI do a "
config module <slot number> disable".
2) Then "
config module <slot number> enable".
3) Go to the unix shell using "
4) Then "
/crossbeam/bin/cbs_reset_slot <slot number>".
After the APM is back in operation should be good to run "show application vap-group <vapgroupname>" to see if the application is up and also verify the health of the application that is running on the blade.
Imported Document ID: 000020000
Subscribing will provide email updates when this Article is updated. Login is required.