How to display the PolicyCenter configuration on PacketShaper using CLI command?
Article ID: 168325
Updated On:
Products
PacketShaper
Issue/Introduction
To find out which PolicyCenter server is connected to a PacketShaper, you can use the Advanced UI in PacketShaper: Setup tab -> PolicyCenter Access.
The setup show CLI command does not show the PolicyCenter server configuration. Is there a CLI command that shows which PolicyCenter server is connected to the PacketShaper?
The setup show CLI command does not show the PolicyCenter server configuration. Is there a CLI command that shows which PolicyCenter server is connected to the PacketShaper?
Resolution
The CLI command to retrieve PolicyCenter server is ds servers.
Here is an output example:
# ds servers
Reference Ct: 6
LDAP Host: 10.10.10.10
LDAP Port: 389
Error:
Error Age: 3719292
Server UTC: 1421006970
UTC Timestamp: 3717162
Server - Local: 228244
newServerTime: true
Here is an output example:
# ds servers
Reference Ct: 6
LDAP Host: 10.10.10.10
LDAP Port: 389
Error:
Error Age: 3719292
Server UTC: 1421006970
UTC Timestamp: 3717162
Server - Local: 228244
newServerTime: true
Feedback
Yes
No
Powered by
