Is there an alert notification if the power supply is faulty on CA appliances?
Article ID: 168834
Updated On:
Products
Content Analysis Software - CA
Issue/Introduction
Content Analysis releases prior to version 3.1.4.0 cannot send an alert notification if the power supply is faulty. When a power supply suffers from a fault, you will not see the PSU listed in Power Supplies under the Utilities > Onboard Diagnostics page.
Resolution
Starting in version 3.1.4.0, you can configure alert notifications for hardware failures, including a faulty power supply:
- In the web console, select Settings > Alert Locations, enable notifications for the Hardware sensor detected a problem event. Refer to Set Up Alert Delivery Methods.
- In the CLI, use the command (config)# alerts destinations <notification_type> HARDWARE_FAILURE. Refer to (config)# alerts destinations.
Feedback
Yes
No
Powered by
