In legacy PacketShaper software versions (8.7, 9.2), the
setup reset all command deletes all measurement data, but it does not work this way in PS 11.x.
In PS 11.2.x, 11.3.x, 11.4.x, and 11.5.1:
setup reset clear removes the folders that store all the configurations, including measurement data.
setup reset all is the same as
setup reset. It resets the PacketShaper settings (for example, NIC speed and IP address, but not the traffic tree) to the factory default state, and then reboots the unit.
Blue Coat has resolved the issue in the PS 220.127.116.11 release.
Please upgrade to PS 18.104.22.168 or later.
Use one of the following CLI commands:
setup reset clear
measure reset after boot up
Note: PacketShaper will restart if you run the
setup reset all command.
Imported Document ID: 000029679
Subscribing will provide email updates when this Article is updated. Login is required.