You are attempting to configure the interfaces on your Edge SWG (formerly ProxySG) appliance to support data speeds of 1 Gbps or higher, but are unable to do so. Upon attempting to make this change you experience the following:
Examples:
At this point you are asked to:
This is an issue with the cables used, with respect to 10G copper bypass and non-bypass NICs.
Based off of information from Bug #203325:
"We only support straight through cables now. We discovered that Intel only supports one specific cross over pattern and we found 3 different cross over wire patterns between our lab and the manufacturing sites. We are replacing the cross over cables used for testing in manufacturing with straight through cables.
The error seen was caused by using the unsupported cross over pattern. Diagnostics removed "crossover" from the the line of output saying that a cable is needed. The error showed up infrequently at 10G, but close to 50% of the time when testing 1G."