The purpose of this article is to provide an explanation as to why the traffic through PacketShaper never reaches the link size and what can be done when this occurs.
An example of this would be as follows:
The link size is configured to 950 Mbps.
There are one or more partitions burstable up to 100% of the link size.
The real throughput never reaches 950 Mbps (around 20% less than the link size)
The device is not allowing any flow to burst above the partition limit even for a fraction of a second, which may slow down applications in response to this control.
The “gPtnBurstLimitMsecs” sys set controls the buffer size used for the partition bandwidth utilization. By default it is set to 0 on versions older than 9.2.5 and 8.7.8. On later versions, the default value is 5. The maximum value is 125 and is measured in milliseconds.
The immediate solution is to set the gPtnBurstLimitMsecs to a value greater than 0. 125 is the value we recommend. This can be done by using the following command:
sys set gPtnBurstLimitMsecs 125
Also, as usual, an upgrade to the latest software version is always advisable.
There is no need to restart the device after changing this value and the effect is immediate.
Imported Document ID: 000032953
Subscribing will provide email updates when this Article is updated. Login is required.