Getting "WebContentLayer Dropped:: "Appliance" From row 1" Error when opening or installing Visual Policy Manager
search cancel

Getting "WebContentLayer Dropped:: "Appliance" From row 1" Error when opening or installing Visual Policy Manager

book

Article ID: 171143

calendar_today

Updated On:

Products

Advanced Secure Gateway Software - ASG ProxySG Software - SGOS

Issue/Introduction

The "WebContentLayer Dropped:: "Appliance" From row 1" message appears when opening the Visual Policy Manager (VPM), when installing the VPM or upgrading from SGOS 6.5 to 6.6

WebContentLayer Dropped:: "Appliance" From row 1

Environment


 

Cause

  • This issue may happen when downgrading SGOS, and the User Interface (UI) is still in an upgraded version
  • It can occur when upgrading from SGOS 6.5.x.x to 6.6.x.x

Resolution

Reset the UI to fix the issue

  1. Close the Visual Policy Manager (VPM).
  2. Reset the user interface. Do this through the Command Line Interface (CLI).
  3. SSH to the proxy, go in to enable mode and type the following commands:
SGOS# conf t
SGOS#(config) ui
SGOS#(config ui) reset
  1. Once the UI is reset via Secure Shell (SSH), go back to the Proxy Management Console and Launch the VPM.
  2. Immediately click on Install.

Note: Do not make any changes to the VPM before installing.

 

Alternative Solution

  • The above steps were not available to a Virtual Proxy on SGOS 6.6.5.18
  • Restarting the Virtual Image did not resolve the issue
  • Upgrade to SGOS 6.7.3.14 or higher