How to Register Symantec Mail Security for Exchange (SMSMSE) With LiveUpdate Manually
Last Updated November 18, 2016
When LiveUpdate is run the virus definitions for SMSMSE are not updated. This article describes how to manually register SMSMSE with LiveUpdate.
LiveUpdate may display one of the following messages when this occurs:
LU has determined that no update is necessary You already have the most recent Definitions and decomposers
During the installation of SMSMSE the installer registers SMSMSE with LiveUpdate. This registration configures LiveUpdate to download virus definitions for SMSMSE. If for some reason SMSMSE is not registered with LiveUpdate then LiveUpdate does not download definitions for SMSMSE.
Use the following steps to manually register SMSMSE with LiveUpdate:
Open a command prompt on the computer where SMSMSE is installed and run the following command:
NOTE: Ensure that Symantec Tamper protection is disabled if a Symantec Endpoint Protection client is installed on same server, otherwise it will not let you register it manually. The following error message may be displayed if Tamper protection is enable:
DllRegisterServer in C:\Program Files (x86)\Symantec\SMSMSE\7.5\Server\SAVFMSELU.dll failed. Return code was: 0x80040154
You can turn it back on once you have successfully registered SAVFMSELU.dll.
After a short time a dialog box with the following message appears:
DllRegisterServer in C:\Program Files (x86)\Symantec\SMSMSE\7.5\Server\SAVFMSELU.dll succeeded.
Attempts to run LiveUpdate should succeed in updating SMSMSE.
Imported Document ID: TECH81935
Subscribing will provide email updates when this Article is updated. Login is required to Subscribe