How to backup and restore settings for Symantec Protection Engine (SPE) 7.0.x

TECH89745
Last Updated June 01, 2017
Copy Article Title/URL
Feedback
Subscribe

You wish to do one of the following:

  • Backup/restore configuration settings for a single computer running SPE.
  • Copy the configuration from a computer running SPE to a different computer running SPE.

NOTE: SPE configuration files are version specific. Restoring SPE configuration files of the wrong version cause the SPE service or daemon to fail to start.

How to backup the SPE configuration:

  1. Stop the Symantec Protection Engine service or daemon.
  2. Copy the configuration files to a different location on your file system.
  3. Start the Symantec Protection Engine service or daemon.

How to restore the SPE configuration:

  1. Stop the Symantec Protection Engine service or daemon.
  2. Copy the backup configuration files from an alternate location on your file system to the Symantec Protection Engine folder over-writing the existing configuration files.
  3. Start the Symantec Protection Engine service or daemon.

How to copy the SPE configuration to a different computer:

1. Stop the Symantec Protection Engine service or daemon.
2. Copy the backup configuration files from an alternate location on your file system to the Symantec Protection Engine folder over-writing the existing configuration files.
3. Open the file configuration.xml in an editor and change the following item to contain the new computer's IP address (there may be more than one line with this value):

 

<BindAddressvalue="10.85.209.155" />

4. Save the file and close the editor.
5. Start the Symantec Protection Engine service or daemon.

 

Configuration Files for SPE

• The configuration for SPE is contained in the following files:

atomicfiltering.xml
category3.xml
configuration.xml
filtering.xml
liveupdate.xml
policy.xml

The location of the file is in the following directory (default location): 

Windows 32-bit operating system: c:\Program Files\Symantec\Scan Engine
Windows 64-bit operating system: c:\Program Files (x86)\Symantec\Scan Engine
Linux/Solaris: /opt/Symantec/SYMCScan/bin

• If the liveupdate.conf file has been modified to include settings such as proxy server values, you will need to include the liveupdate.conf in your backup.

  The location of the file for Protection Engine 7.0.x is the SPE installation folder.

Windows 32-bit default location: C:\Program Files\Symantec\Scan Engine
Windows 64-bit default location: C:\Program Files (x86)\Symantec\Scan Engine

 

 

 

 

Imported Document ID: TECH89745
Legacy ID: 2008061916073154

Thanks for your feedback. Let us know if you have additional comments below. (requires login)

    © 1995-2019 Broadcom. All Rights Reserved. The term “Broadcom” refers to Broadcom Inc. and/or its subsidiaries.